Signage

Traffic light poles

by Pali Campion Srl

View Pali Campion Srl on TEKEN44

Stricter regulations for building safety testing, as well as the requirements of the "new highway code," have led to the need for supports with much higher performance than those used in the past. Our answer was the octagonal-section traffic light pole with curved arm, which exploits the potential of sheet metal pole technology and at the same time respects the aesthetic tradition of traffic light poles with curved arms. Octagonal-section traffic light poles with curved arms, manufactured under ISO9001 certified quality control and by an authorised transformation centre according to Ministerial Decree 14/01/08, composed of 2 elements (pillar + arm) to be assembled on site by forced interlocking by overlapping, obtained by cold forming a trapezium of steel sheet and subsequent external longitudinal welding performed with an approved automatic MAG process and welding quality control according to EN ISO 3834. Material: Steel S355JO EN 10025 Corrosion protection through hot-dip galvanizing, achieved through the following cycle: degreasing; pickling; washing; fluxing; preheating; galvanizing in molten zinc at 440-450 degrees Celsius, with a minimum zinc content in the galvanizing bath of ³ 98.5%. Coating obtained in compliance with UNI EN ISO 1461 with a minimum thickness of 55 microns and an average of 70 microns. Optional external painting, in a color chosen from our color chart, with a wrinkled effect, achieved through a thermosetting powder coating process, including: cleaning of any galvanizing residues; smoothing of surfaces using light mechanical action; cleaning of surfaces to remove oil and dirt in general and create a good adhesion base; application by electrostatic spraying of polyester powder suitable for hot-dip galvanized surfaces intended for exterior use, up to a thickness of 60-80 microns; Curing in an oven at a constant temperature of approximately 200°C for 40-50 minutes. Each post is individually wrapped in 100% polyester non-woven fabric (no bubble wrap) to prevent damage to the paint during handling, transportation, and storage. The resulting coating will have the following characteristics: average thickness 60 microns, resistance to ISO 2409 cross-hatching tests, resistance to UNI 8901 impact tests. All steel structural components, in compliance with CE, are manufactured according to EN 1090 in execution class ECX2, certified by a third party body according to European directive EU 305/2011.